This
warning light illuminates when the
ignition switch is turned to the "ON"
position and turns off after the engine
has started. This indicates that the warning
system is working properly.
While the engine is running, this warning light illuminates when a malfunction has been detected in the electric power steering system.
CAUTION
When the power steering warning light is illuminated, there may be more resistance when the steering wheel is operated. Drive carefully to the nearest SUBARU dealer and have the vehicle inspected immediately
NOTE
If the steering wheel is operated in the following ways, the power steering control system may temporarily limit the power assist in order to prevent the system components, such as the control computer and drive motor, from overheating
At this time, there will be more resistance when steering. However this is not a malfunction. Normal steering force will be restored after the steering wheel is not operated for a while and the power steering control system has an opportunity to cool down. However, if the power steering is operated in a non-standard way which causes power assist limitation to occur too frequently, that may result in a malfunction of the power steering control system.
All-Wheel Drive warning light (CVT models)Installation
COOLING(H4DO) > Water Pipe AssemblyINSTALLATION1. WATER PIPE ASSEMBLY RH1. Set the water pipe assembly RH on the engine, and connect the water pipe hose RH (B) to the oil pan upper.2. Secure the water pipe assembly RH to the cylinder head RH with bolt (A).Tightening torque:6.4 N·m (0.7 kgf ...
Assembly
DRIVE SHAFT SYSTEM > Front Drive ShaftASSEMBLY1. Roll up a thick piece of paper to a size where the shaft can pass through, and affix with tape to form a cylinder.2. Attach a new O-ring on this cylinder.CAUTION:• Always use a new O-ring.• Be careful that the O-ring does not become scr ...
Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Learning ControlPROCEDURE1. PREPARATION FOR LEARNING1. Warm up or cool down until the ATF temperature displayed on the Subaru Select Monitor is 40 — 65°C (104 — 149°F).2. After stopping the vehicle, shift the select leve ...