Subaru Crosstrek Service Manual: Power assisted system (power steering) (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc c2552 motor relay
- Dtc u1120 lost communication with autostart stop control module
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc c2511 torque sensor main
- Dtc c2512 torque sensor sub
- Dtc c2513 torque sensor much tolerance
- Dtc c2514 torque sensor power supply
- Dtc c2521 motor malfunction
- Dtc c2522 resolver sensor
- Dtc c2531 control module cpu
- Dtc c2532 control module peripheral circuit
- Dtc c2533 control module board temperature sensor
- Dtc c2541 vehicle dynamics control module vehicle speed sensor
- Dtc c2543 error passive
- Dtc c2551 power supply relay
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0073 control module communication bus off
- General description
- Steering warning light
- Subaru select monitor
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Electrical component location Location
- Inspection mode Procedure
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
Wheel bearing Inspection
PERIODIC MAINTENANCE SERVICES > Wheel BearingINSPECTION1. FRONT WHEEL BEARINGNOTE:Inspect the condition of front wheel bearing grease.1. Jack-up the front side of vehicle.2. While holding the front ...
Other materials:
Head restraint angle adjustment
The angle of the head restraint can be
adjusted in several steps. While maintaining
a suitable driving posture, adjust the
head restraint to a position where the back
of your head is as close to the head
restraint as possible.
To tilt:
Tilt the head restraint by hand to the
preferred p ...
Rear tie-down holes
Rear tie-down hole
The rear tie-down holes are located near
each of the jack-up reinforcements.
There is a plug in each rear tie-down hole.
To use the rear tie-down holes, remove
the plugs. After using the rear tie-down
holes, return the plugs to their original
places.
WARNING
...
Operation
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Code(s) DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display ...
