Passive arming mode
When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED.
Passive arming mode
When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED.
To enter the passive mode
If you wish to program the passive arming mode, have it done by your SUBARU dealer.
Arming the system
CAUTION
In passive mode, the system will automatically activate the alarm but WILL NOT automatically lock the doors. In order to lock the doors you must either lock them as indicated in step 4 below or with the key once they have been closed.
Failure to lock the doors manually will result in a higher security risk.
1. Turn the ignition switch to the "ON" position.
2. Turn the ignition switch from "ON" to "LOCK" position and remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Before closing the doors, lock all doors with the inside door lock levers.
5. Close the doors. The system will automatically arm after 1 minute.
In the passive mode, the system can also be armed with the remote transmitter or with the power door locking switches. If the remote transmitter or power door locking switch is used to lock the vehicle, arming will take place immediately regardless of whether or not the passive mode has been selected.
Disarming the system
To disarm the system, briefly press the
" " button on the transmitter.
Dtc p013f o2 sensor delayed response - lean to rich bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013F O2 SENSOR DELAYED RESPONSE - LEAN TO RICH BANK 1 SENSOR 2NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESP ...
Dtc b1615 front sub sensor lh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1615 FRONT SUB SENSOR LH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front sub sensor (LH) is faulty.If DTC B1615 is displayed, the circuit within the front sub sensor (LH) is faulty ...
Removal
BRAKE > Rear Brake PadREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the rear brake pad.(1) Remove the bolts and remove the brake hose bracket.(2) Remove the caliper bolt, and raise and hold the caliper body assembly.NOTE:Do not disconnect the brake hose from the caliper ...