To set the parking brake, depress the brake pedal firmly and hold it down until the parking brake lever is fully pulled up.
To release the parking brake, pull the lever up slightly, press the release button, then lower the lever while keeping the button pressed.
When the parking brake is set while the engine is running, the parking brake warning light illuminates. After starting the vehicle, be sure that the warning light has turned off before the vehicle is driven.
Refer to "Brake system warning light (red)" F3-21.
CAUTION
Never drive while the parking brake is set because this will cause unnecessary wear on the brake linings.
Before starting to drive, always make sure that the parking brake has been fully released.
Adjustment
CLUTCH SYSTEM > Clutch SwitchADJUSTMENT1. Loosen the lock nut of the clutch start switch.(A)Lock nut(B)Clutch start switch2. Disconnect the harness connector of the clutch start switch.3. Remove the snap pin and clevis pin connecting the clutch pedal and operating rod.(A)Clevis pin(B)Snap pin(C)P ...
Dtc p013e o2 sensor delayed response - rich to lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013E O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 2NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESP ...
Replacement
PERIODIC MAINTENANCE SERVICES > Front & Rear Differential Gear OilREPLACEMENT1. FRONT DIFFERENTIAL (MT MODEL)Front differential gear oil of MT model lubricates the transmission and differential together. Refer to “5MT” section for replacement procedure. Transmission Gear Oil > ...