Subaru Crosstrek Owners Manual: Outside temperature indicator
- U.S.-spec. models
- Except U.S.-spec. models
The outside temperature indicator shows the outside temperature in a range from −40 to 1228F (−40 to 508C).
The indicator can give a false reading under any of the following conditions.
- When there is too much sun.
- During idling; while running at low speeds in a traffic jam; when the engine is restarted immediately following a shutdown.
- When the actual outside temperature falls outside the specified indicator range.
Road surface freeze warning indication
- U.S.-spec. models
- Except U.S.-spec. models
When the outside temperature drops to 378F (38C) or lower, the temperature indication flashes to show that the road surface may be frozen.
If the outside temperature drops to 378F (38C) or lower while the display is giving an indication other than the outside temperature, the display switches to the outside temperature indication and flashes for 5 seconds before returning to its original indication.
If the display is already indicating an outside temperature of 378F (38C) or lower when the ignition switch is turned to the "ON" position, the indication does not flash.
NOTE
The outside temperature indication may differ from the actual outside temperature. The road surface freeze warning indication should be treated only as a guide. Be sure to check the condition of the road surface before driving.
Information display (if equipped)
NOTE
For models with color multi function
display, refer to "Multi function display"
Outside temperature indicator
Driving information display
Clock
With the ignition switch in the "A ...
Driving information display
Information display selection knob
With the ignition switch in the "ON"
position, each successive press of the
information display selection knob
switches the display in the following seq ...
Other materials:
Inspection
LIGHTING SYSTEM > Combination Switch (Light)INSPECTIONMeasure the resistance between connector terminals. If it is not within the standard value, replace the switch assembly - combination turn dimmer.Preparation tool:Circuit tester1. LIGHTING SWITCHTerminal No.Inspection conditionsStandard18 — ...
Charge warning light
If
this light illuminates when the engine is
running, it may indicate that the charging
system is not working properly.
If the light illuminates while driving or does
not turn off after the engine starts, stop the
engine at the first safe opportunity and
check the alternator belt. If the ...
Removal
DRIVE SHAFT SYSTEM > Propeller ShaftREMOVALCAUTION:• Before removing propeller shaft, wrap metal parts with a cloth or rubber material.• Do not disassemble the center EDJ of the propeller shaft.• Before removing propeller shaft, wrap the metal parts attached to the rubber boot o ...
