Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Other markings

The following makings are also placed on the sidewall.

Maximum permissible inflation pressure

The maximum cold inflation pressure to which this tire may be inflated. For example, "300 kPa (44 PSI) MAX. PRESS"

Maximum load rating

The load rating at the maximum permissible weight load for this tire.

For example, "MAX. LOAD 580 kg (1279 LBS) @ 300 kPa (44 PSI) MAX. PRESS."

WARNING

Maximum load rating applies only to the tire, not to the vehicle. Putting a load rated tire on any vehicle does not mean the vehicle can be loaded up to the tire's rated load.

Construction type

Applicable construction of this tire.

For example, "TUBELESS STEEL BELTED RADIAL"

Construction

The generic name of each cord material used in the plies (both sidewall and tread area) of this tire.

For example, "PLIES: TREAD 2 STEEL + 2 POLYESTER SIDEWALL 2 POLYESTER"

Uniform Tire Quality Grading (UTQG)

For details, refer to "Uniform tire quality grading standards" F13-15.

Tire Identification Number (TIN)
Tire Identification Number (TIN) is marked on the intended outboard sidewall. The TIN is composed of four groups. Here is a brief review of the TIN with a breakdown of its individual elements. ( ...

Recommended tire inflation pressure
Recommended cold tire inflation pressure For recommended cold tire inflation pressure for your vehicle's tires, refer to "Tires" F12-8. Vehicle placard The vehicle placard is attached to th ...

Other materials:

Engine control module (ecm) i/o signal Electrical specification
ENGINE (DIAGNOSTICS)(H4DO) > Engine Control Module (ECM) I/O SignalELECTRICAL SPECIFICATION1. ENGINE CONTROL MODULE (ECM)DescriptionConnector No.Terminal No.Signal (V)NoteIgnition SW ON(Engine OFF)Engine ON(Idling)Crankshaft position sensor(+) signalB1361650 or 5Waveform*(−) signalB1362700 ...

Dtc p1451 evap system clog detected (pipe)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1451 EVAP SYSTEM CLOG DETECTED (PIPE)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear M ...

Inspection
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > General DescriptionINSPECTIONBefore performing the diagnosis, check the following items which may cause problems relating the wiper or light.1. Check the battery. Battery">2. Check the fuse condition.3. Check the connecting condition of harness ...

© 2016-2026 Copyright www.sucross.com