Subaru Crosstrek Service Manual: Ornament Installation
EXTERIOR/INTERIOR TRIM > Ornament
INSTALLATION
1. LETTER MARK
Align the end of application tape with the end of panel, then adhere the letter mark.
(a) | Panel - rear gate end | (b) | Application tape end |
NOTE:
• Align the cutout of application tape with the end reference of the front door. (a)
• Align the upper end of application tape with the end of rounded corner of character line. (b)
Heat shield cover Note
EXTERIOR/INTERIOR TRIM > Heat Shield CoverNOTERefer to “EXHAUST” section for removal and installation procedure of the heat shield cover. ...
Other materials:
Dtc b1625 side airbag sensor lh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1625 SIDE AIRBAG SENSOR LH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Side airbag sensor (LH) is faulty.When DTC B1625 is displayed, the circuit within the side airbag sensor (LH) i ...
Rear center seatbelt
Center seatbelt tongue plate
Connector (tongue)
Connector (buckle)
Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing
twisted can increase the risk or
severity of injury in an accident.
When fastening the belt after it is
pulled out from the retractor, ...
Caution
EyeSight > General DescriptionCAUTION• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before ...
