INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > System Operation Check Mode
OPERATION
1. COMBINATION METER
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Combination Meter» and then select «Enter».
5. On «Select Function» display, select «Active Test».
6. On «Active Test» display, select an item to be checked.
NOTE:
• For detailed operation procedures, refer to “Application help”.
• If not equipped (depending on destination area or vehicle equipment condition), process will not go on.
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. Clear Memory Mode > OPERATION">
Dtc p0102 mass or volume air flow sensor "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0102 MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving performance ...
Features
The multi function display has the following
functions.
Description
Displays useful messages, such
as warning information, etc.
Displays basic screens (e.g. fuel
consumption screen, etc.)
Sets and adjusts maintenance
notification
Registers driving history
Sets and customizes car operation
...
Communication for initializing impossible
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Subaru Select MonitorCOMMUNICATION FOR INITIALIZING IMPOSSIBLENOTE:Confirm that the LAN system is working properly before the diagnosis.Subaru Select Monitor communication line is open or shorted.Detecting condition:• Defective ha ...