Subaru Crosstrek Service Manual: Operation
GLASS/WINDOWS/MIRRORS > Power Window System
OPERATION
1. RESET OPERATION A
1. Sit in the driver’s seat and close the door.
2. Turn the ignition switch to ON.
3. Operate the switch - power window main to open the glass assembly - front door halfway.
4. Operate the switch - power window main in “UP” direction to fully close the glass assembly - front door on the driver’s side.
5. While the glass assembly - front door is fully closed, hold down the switch - power window main in “UP” direction for one second.
6. Operate the switch - power window main in “AUTO DOWN” direction to check whether the window fully opens properly.
NOTE:
If the window does not fully open properly, repeat steps 1) to 6).
2. RESET OPERATION B
1. Sit in the driver’s seat and close the door.
2. Turn the ignition switch to ON.
3. On the glass assembly - front door of the driver’s side, operate the “AUTO UP” function (fully pull up the switch) using the switch - power window main, and perform auto-reverse operations 10 times in a row (after the window fully closes, it slightly opens).
4. Check that the “AUTO UP” function no longer operates.
5. Perform reset operation A.
6. Check that the window operates properly by operating the “AUTO UP” and “AUTO DOWN” switch.
NOTE:
If the window does not fully open/close properly, repeat steps 1) to 6).
Note
GLASS/WINDOWS/MIRRORS > Power Window SystemNOTEFor operation procedures of each component of the power window system, refer to the respective sections.• Power window control switch: Power Wi ...
Rear door glass
...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...
Dtc c0074 master cylinder pressure sensor output
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0074 MASTER CYLINDER PRESSURE SENSOR OUTPUTDTC detecting condition:Defective pressure sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• EyeSight does no ...
Removal
EXTERIOR/INTERIOR TRIM > Door TrimREMOVAL1. FRONT DOOR1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - front door.(1) Attach the protective tape (a).(2) Open the cover and remove the screw.(3) Remove the clips, and remove the trim panel - front door from the ...
