EyeSight (DIAGNOSTICS) > Freeze Frame Data Display
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «EyeSight» and select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «FFD».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• Freeze frame data is stored for three DTCs. Allocation of the three DTCs are as follows:
– DTC that occurred first.
– DTC that occurred first during the latest driving cycle (from IGN ON to IGN OFF).
– DTC that occurred first during the second latest driving cycle.
– However, DTCs will be stored in order of occurrence until these three DTCs are stored.
• For details on freeze frame data, refer to List of freeze frame data. Freeze Frame Data Display > LIST">
• Freeze frame data is cleared in Clear Memory Mode. Clear Memory Mode">
Caution
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage the ...
Blind Spot Detection (BSD)
Operating range
The system warns the driver of dangers as
follows.
If the system detects vehicles in the
driver's blind spots, the BSD/RCTA approach
indicator light(s) on the outside
mirror(s) will illuminate.
If the driver operates the turn signal
lever to the side where th ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...