Subaru Crosstrek Service Manual: Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «EyeSight» and select «Enter».

5. On «Select Function» display, select «DTC».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. Diagnostic Code(s) Display > LIST">

• Up to ten codes can be stored. When more than ten codes are output, they will not be stored.

• The same code is stored only once, and even when the same code occurs several times, information will not be updated.

List

Diagnostic procedure with diagnostic trouble code (dtc)

Other materials:

Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the "ON" position then move the select lever to the "P" position with the select lever button pressed and brake pedal depressed. If the select lever does not move after performing the above procedure, perform the follo ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.Install in the reverse order of removal.NOTE:• Use new O-rings.&bul ...

Dtc p0756 shift solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0756 SHIFT SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor ...