CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AT OIL TEMP Warning Light Display
OPERATION
The AT OIL TEMP light illuminates or blinks, when the ATF temperature is high and malfunction occurs in CVT.
• At normal condition
After turning the ignition switch to ON, illuminates for 2 seconds then goes off.
• When ATF temperature is high
AT OIL TEMP light illuminates when the ATF temperature is abnormally high with the ignition switch ON.
• When malfunction is detected
AT OIL TEMP light blinks at 2 Hz when the TCM detects the malfunction of CVT with the ignition switch ON. In this case, inspect using “Diagnostic Procedure with Diagnostic Trouble Code (DTC)”. Diagnostic Procedure with Diagnostic Trouble Code (DTC)">
• When AT learning is not finished
AT OIL TEMP light repeats “Blinking at 4 Hz > Turning OFF” every two seconds, when the AT learning is not completed with the ignition switch ON. In this case, perform the “Learning”. (During AT learning, the light blinks at 2 Hz or illuminates.) Learning Control">
(A) | Ignition switch condition | ||||
(1) | At normal condition | (3) | When malfunction is detected | (4) | When AT learning is not finished |
(2) | When ATF temperature is high |
If the AT OIL TEMP light does not illuminate, or illumination patterns are not as above, check the AT OIL TEMP light circuit. AT OIL TEMP Warning Light Display > INSPECTION">
Inspection
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSPECTIONWARNING:• As batteries produce flammable gases, be careful not to bring an open flame close to the batteries.• Ventilate sufficiently when using or charging battery in enclosed space.• Electrolyte is corrosive acid, and has toxi ...
Dtc p0516 battery temperature sensor circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0516 BATTERY TEMPERATURE SENSOR CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATIO ...
Registering a Bluetooth Audio device for the first time
To use the Bluetooth Audio, it is necessary
to register an audio device with the
system.
The device registration procedure is the
same for both the hands-free system and Bluetooth audio.
1. Display the "BT Devices Connection"
screen. Refer to "Registering a Bluetooth
phone for the first tim ...