Subaru Crosstrek Service Manual: Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Body Control» and then select «Enter».

5. On «Select Function» display, select «Data Monitor».

NOTE:

For detailed operation procedures, refer to “Application help”.

Read current data

List

Other materials:

Dtc c2421 transmitter 1 battery voltage low
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2421 TRANSMITTER 1 BATTERY VOLTAGE LOWNOTE:Refer to DTC C2424 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2424 TRANSMITTER 4 BATTERY VOLTAGE ...

Removal
SECURITY AND LOCKS > Front Inner RemoteREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the screw, and remove the remote assembly - door.CAUTIO ...

Starting and stopping the engine (models without push-button start system)
CAUTION When operating the Subaru Ascent starter motor, never crank the engine continuously for more than 10 seconds. If the engine of the Subaru Ascent does not start within 5 to 10 seconds, stop cranking and wait at least 10 seconds before attempting again. This pause helps prevent overh ...