Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Operating cylinder

Installation
CLUTCH SYSTEM > Master CylinderINSTALLATION1. Install the master cylinder to the body, and connect the clutch pipe and the tank hose.Tightening torque:T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)T2: 1 ...

Assembly
CLUTCH SYSTEM > Operating CylinderASSEMBLYNOTE:During assembly, apply hydraulic oil to all parts.Recommended brake fluid:New FMVSS No. 116 DOT3 or DOT41. Install the piston spring.2. Insert piston ...

Other materials:

Dtc c0071 steer angle sensor op
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0071 STEER ANGLE SENSOR OPDTC detecting condition:Steering angle sensor output is faulty.Trouble symptom:• VDC does not operate.• EyeSight does not operate.Wiring diagram:Vehicle ...

Inspection
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSPECTION1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ignition switch to ON. (Engine OFF)3. Measure the voltage between ECM connector terminals.• Main ...

Component
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCOMPONENT1. STARTER(1)Starter housing ASSY(9)Overrunning clutch(17)Sleeve bearing(2)Sleeve bearing(10)Internal gear ASSY(18)Starter cover ASSY(3)Shift lever(11)Shaft (4)Plate(12)Pinion gearTightening torque: N·m (kgf-m, ft-lb)(5)Seal rub ...

© 2016-2025 Copyright www.sucross.com