Installation
InspectionGeneral diagnostic table Inspection
BRAKE > General Diagnostic TableINSPECTION Trouble and possible causeCorrective action1. Insufficient braking(1) Fluid leakage from the hydraulic mechanismRepair or replace. (cup, piston seal, piston boot, master cylinder piston kit, pipe or hose)(2) Entry of air into the hydraulic mechanismBleed ...
Installation
CONTROL SYSTEMS > Select CableINSTALLATION1. Position the select cable as shown in the figure, and install it to the plate assembly.CAUTION:• If the cable is installed in the wrong direction, loosen the bracket bolts, and then reinstall the cable in the correct direction.• Do not adju ...
Rear center seating position
CAUTION
The head restraint is not intended to
be used at the retracted position.
Before sitting on the seat, raise the
head restraint to the extended position.
Incorrect (retracted position)
Correct (extended position)
To raise:
Pull the head restraint up.
To lower:
Push ...