Subaru Crosstrek Owners Manual: OFF delay timer
The following lights have an automatic illumination function.
- dome light
- map light (type A)
- cargo area light
After being illuminated automatically, these lights remain on for several seconds and then gradually turn off under the following conditions
after all doors are closed (type A map light)
after the rear gate is closed (cargo area light)
While the lights are illuminated, if any of the following operations are performed, the lights turn off immediately.
- The ignition switch is turned from the "LOCK"/"OFF" position to the "ACC" or "ON" position.
- All doors and the rear gate are locked using the keyless access function (if equipped).
- All doors and the rear gate are locked using the remote keyless entry system.
The setting for the period of time in which the lights remain on (OFF delay timer) can be changed by a SUBARU dealer. Contact your SUBARU dealer for details. For models with multi function display, the setting can be changed by operating the multi function display. For details, refer to "Interior light off delay timer setting"
Map lights
Type A
Type B
To turn on the map light, push the switch.
To turn it off, push the switch again.
NOTE
For the type A map lights, although the
light switches are in the ON position,
the lig ...
Sun visors
To block out glare, swing down the visors.
To use the sun visor at a side window,
swing it down and move it sideways. ...
Other materials:
Installation
MECHANICAL(H4DO) > Cylinder BlockINSTALLATION1. Apply engine oil to the crankshaft bearing, and install the crankshaft bearing to the cylinder block.CAUTION:• Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.• ...
Airflow mode selection
In the Subaru Ascent, airflow direction can be customized manually to suit different
driving conditions and passenger comfort preferences. To select the desired airflow
mode, follow the steps below.
1. Tap the climate control mode indicator on the display.
2. Choose the preferred airflow distr ...
Installation
EXTERIOR/INTERIOR TRIM > Front Under CoverINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).Install each part in the reverse order of removal.Tightenin ...
