Subaru Crosstrek Service Manual: Neutral position switch Note
CRUISE CONTROL SYSTEM > Neutral Position Switch
NOTE
For the operation procedures for neutral position switch, refer to “MANUAL TRANSMISSION AND DIFFERENTIAL” section. Switches and Harness">
Inhibitor switch Note
CRUISE CONTROL SYSTEM > Inhibitor SwitchNOTEFor the operation procedures for inhibitor switch, refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. Inhibitor Switch"> ...
Stop light brake switch Note
CRUISE CONTROL SYSTEM > Stop Light & Brake SwitchNOTEFor the operation procedures for stop light and brake switch, refer to “BRAKE” section. Stop Light Switch"> ...
Other materials:
Disassembly
CLUTCH SYSTEM > Clutch PedalDISASSEMBLY1. Remove the clutch switches.2. Remove the clip, assist spring, rod and bushing.(A)Clip(B)Assist spring(C)Assist rod(D)Bushing(E)Clevis pin3. Remove the spring pin and lever.(A)Spring pin(B)Lever4. Remove the clutch pedal and pedal bushings.(A)Clutch pedal( ...
Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner CaseREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B).4. ...
Basic diagnostic procedure Procedure
LAN SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).• Remove foreign matter (dust, water, oil, etc.) from each control modu ...
