Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Multi information display (models with type B combination meter)

Subaru Crosstrek Owners Manual / Instruments and controls / Multi information display (models with type B combination meter)

WARNING

Always pay adequate attention to safe driving when operating the multi information display while the vehicle is in motion. When operation of the multi information display interferes with your ability to concentrate on driving, stop the vehicle before performing operations on the screen. Also, do not concentrate on the display while driving. Doing so may cause you to look away from the road and could result in an accident.

Various information will be shown on the multi information display. Also, a warning message will appear on the display if a malfunction, etc. is detected. In addition, several settings for the displayed content can be performed.

Multi information display

Multi information display

  1. Fuel gauge (refer to "Fuel gauge" 3- 12.)
  2. Warning screen (refer to "Warning screen" 3-39.)/Basic screen (refer to "Basic screens" 3-39.)
  3. Cruise control information display
  4. Warning indicator
  5. Select lever/gear position indicator (refer to "Select lever/gear position indicator (CVT models)"
  6. Odometer (refer to "Odometer" 3-10.)/ double trip meter (refer to "Double trip meter"

Control switch

Control switch

  1. Up (select)
  2. Set (enter)
  3. Down (select)
Clock
To adjust the time shown by the clock, press the "+" button or "−" button. If you press the "+" button, the indicated time will change in one-minute increments. If you press the "− ...

Basic operation
By operating "  " or "  " of the control switch, the screens and selection items can be switched. When the " /SET" switch is pulled toward you, the item can be selected and set. ...

Other materials:

Dtc b2220 break the wire of ign
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2220 BREAK THE WIRE OF IGNDTC detecting condition:There was voltage malfunction caused by poor contact of IGN power supply circuits.Trouble symptom:Airbag indicator does not illuminate.Wiring d ...

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialDISASSEMBLYRemove the ball bearing using ST.NOTE:Center differential is a non-disassembled part which should not be disassembled.ST 498077300CENTER DIFFERENTIAL BEARING REMOVER ...

Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General DescriptionINSPECTION1. BASIC INSPECTIONBefore performing diagnosis, check the following items that might provoke the problems related to BSD/RCTA.1. Check the battery. Battery">2. Check the relay and fuse condition. ...

© 2016-2022 Copyright www.sucross.com