Subaru Crosstrek Owners Manual: Models without "keyless access with push-button start system"

Automatic engine shutdown

The remote engine start system will automatically shut down or will not start the engine under the following conditions. The total run-time has exceeded 20 minutes. Any door or the rear gate ...

Starting the engine

NOTE All vehicle doors (including rear gate) and the engine hood must be closed prior to activating the remote engine start system. Any open entry point will prevent starting or cause the engine ...

Other materials:

Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...

Installation
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSTALLATION1. Place the rear brake back plate between the rear axle housing and the rear hub unit bearing, and tighten the bolt.CAUTION:• Be careful not to damage the magnetic encoder.• Do not get closer the tool which charged magnetism to ma ...

Dtc p0977 shift solenoid "b" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0977 SHIFT SOLENOID "B" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not changed. (No down-shift)CAUTION:Use the check bo ...