Type A
Type B
To turn on the map light, push the switch.
To turn it off, push the switch again.
NOTE
For the type A map lights, although the light switches are in the ON position, the lights are automatically turned off after approximately 30 seconds of illumination to prevent the vehicle battery from discharging. For details, refer to "Battery drainage prevention function"
Automatic illumination (models with moonroof)
The map lights illuminate automatically in the following cases.
Refer to "Locking and unlocking with "keyless access" entry function"
Dtc c1423 different ecu specifications
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1423 DIFFERENT ECU SPECIFICATIONSDTC detecting condition:Different control module specificationTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start as ...
Installation
EXTERIOR/INTERIOR TRIM > Rear BumperINSTALLATIONInstall each part in the reverse order of removal.CAUTION:Before installing the bumper face, match the claws on the bracket - rear bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyADJUSTMENT1. THRUST BEARING PRELOAD1. Select a suitable adjusting washer No. 1 so that dimension (H) will be zero in a visual check. Position the washer (18.3 ? 30 ? t) and lock washer (18 ? 30 ? 2) and attach the lock nut.2. ...