Subaru Crosstrek Owners Manual: Manual transmission oil
It is not necessary to check the transmission oil level. Check that there are no cracks, damage or leakage. However, the oil inspection should be performed according to the maintenance schedule in the "Warranty and Maintenance Booklet".
Consult your SUBARU dealer for details.
Recommended grade and viscosity
Each oil manufacturer has its own base oils and additives. Never use different brands together. For details, refer to "Manual transmission, front differential and rear differential gear oil" F12-6.
Drive belts
It is unnecessary to check the deflection of
the drive belt periodically because your
engine is equipped with an automatic belt
tension adjuster. However, replacement of
the belt should be done ac ...
Continuously variable transmission fluid
It is not necessary to check the transmission
fluid level. Check that there are no
cracks, damage or leakage. However, the
fluid inspection should be performed
according to the maintenance schedul ...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the rear hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the rear h ...
Location
LIGHTING SYSTEM > Relay and FuseLOCATIONMain fuse boxHeadlight relay (HI)(A)Headlight relay (LO)(B)Fuse 15 A (daytime running light relay)(C)Fuse 30 A (combination light LH/RH)(D)Fuse 20 A (spot map light, room light, ignition switch illumination (immobilizer antenna))(E)Fuse 15 A (tail and illum ...
Dtc p0842 transmission fluid pressure sensor/switch "a" circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0842 TRANSMISSION FLUID PRESSURE SENSOR/SWITCH "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Shift characteristics malfunctionCAUTION:U ...
