Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Manual transmission

Manual transmission

The manual transmission is a fully synchromeshed, 5-forward-speed and 1-reverse- speed transmission.

The shift pattern is shown on the shift lever knob. When shifting from 5th gear to reverse gear, first return the shift lever to the neutral position then shift into reverse gear.

To change gears, fully depress the clutch pedal, move the shift lever, and gradually let up on the clutch pedal.

If it is difficult to shift into gear, put the transmission in neutral, release the clutch pedal momentarily, and then try again.

WARNING

CAUTION

Shift into reverse ONLY when the vehicle has completely stopped. It may cause damage to the transmission to try shifting into reverse when the vehicle is moving.

System maintenance
NOTE For models without "keyless access with push-button start system": In the event that the vehicle's battery is replaced, discharged or disconnected, it will be necessary to start the vehicle ...

Shifting speeds
Recommended shifting speeds The best compromise between fuel economy and vehicle performance during normal driving is ensured by shifting up at the speeds listed in the following table. Maximum ...

Other materials:

Inspection
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > General DescriptionINSPECTIONBefore performing the diagnosis, check the following items which may cause problems relating the wiper or light.1. Check the battery. Battery">2. Check the fuse condition.3. Check the connecting condition of harness ...

Installation
CLUTCH SYSTEM > Clutch PedalINSTALLATION1. Install in the reverse order of removal.CAUTION:Always use a new clevis pin.Tightening torque:Clutch pedal18 N·m (1.8 kgf-m, 13.3 ft-lb)Knee airbag module7.5 N·m (0.76 kgf-m, 5.5 ft-lb)Air intake boot3 N·m (0.3 kgf-m, 2.2 ft-lb)2. Ad ...

Dtc u0100 lost communication with ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLINE OF DIA ...

© 2016-2022 Copyright www.sucross.com