ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator Light
MALFUNCTION INDICATOR LIGHT REMAINS BLINKING
Diagnosis:
The delivery (test) mode fuse circuit is short-circuited to ground.
Trouble symptom:
Malfunction indicator light blinks when delivery (test) mode fuse is not connected.
Wiring diagram:
Engine electrical system Engine Electrical System">
STEP | CHECK | YES | NO |
1.CHECK DELIVERY (TEST) MODE CONNECTOR.
1) Check the delivery (test) mode fuse is removed.
2) Turn the ignition switch to ON.
Does the malfunction indicator light blink?
Malfunction Indicator Light > MALFUNCTION INDICATOR LIGHT REMAINS BLINKING">Go to Step 2.
System is normal.
NOTE:
Malfunction indicator light blinks at a cycle of 3 Hz when delivery (test) mode fuse is attached.
2.CHECK HARNESS BETWEEN ECM AND DELIVERY (TEST) MODE FUSE.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ECM.
3) Measure the resistance between ECM connector and chassis ground.
Connector & terminal
(B137) No. 13 — Chassis ground:
Is the resistance 1 M? or more?
Replace the ECM. Engine Control Module (ECM)">
Repair the short circuit to ground in the harness between the ECM connector and delivery (test) mode fuse.
Access key - if access key does not operate properly
CAUTION
Keep metallic objects, magnetic
sources and signal transmitters
away from the area between the
access key and the push-button
ignition switch. They may interfere
with the communication between
the access key and the push-button
ignition switch.
The following functions may be inopera ...
Read current data Operation
EyeSight (DIAGNOSTICS) > Read Current DataOPERATION1. STEREO CAMERA1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, ...
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the front wheels.3. Remove the front ABS wheel speed sensor.CAUTION:• Be careful not to damage the sensor.• Do not ap ...