Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Malfunction indicator light does not come on

ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator Light

MALFUNCTION INDICATOR LIGHT DOES NOT COME ON

TROUBLE SYMPTOM:

When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.

NOTE:

Refer to IDI section for diagnostic procedure. Basic Diagnostic Procedure">

Activation of malfunction indicator light
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightACTIVATION OF MALFUNCTION INDICATOR LIGHT1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the ...

Malfunction indicator light does not go off
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT GO OFFTROUBLE SYMPTOM:Although malfunction indicator light comes on when the engine runs, DTC is not sho ...

Other materials:

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...

Dtc b11e0 rollover deployment history
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11E0 ROLLOVER DEPLOYMENT HISTORYDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is indicated when the curtain airbag module and the seat belt pretensioner are deployed.Once this DTC is ...

Safety precautions
WARNING Never attempt to remove the radiator cap until the engine has been shut off and has cooled down completely. Since the coolant is under pressure, you may suffer serious burns from a spray of boiling hot coolant when the cap is removed. CAUTION Vehicles are filled at the factory ...

© 2016-2024 Copyright www.sucross.com