NOTE
If you unlock the driver's door with a key (including a mechanical key) and open the door while the alarm system is armed, the alarm system is triggered and the vehicle's horn sounds. In this case, perform any of the following operations:
Models with "keyless access with push-button start system":
Press any button on the access key (except when the access key battery is discharged).
Press the push-button ignition switch to "ACC".
Carry the access key and perform either of the following procedures.
Models without "keyless access with push-button start system":
For details about the alarm system, refer to "Alarm system" 2-26.
To lock the driver's door from the outside with the key, turn the key toward the front.
To unlock the door, turn the key toward the rear. Pull the outside door handle to open an unlocked door.
NOTE
For models with "keyless access with push-button start system": The mechanical key is directional. If the key cannot be inserted, change the direction that the grooved side is facing and insert it again.
To lock the door from outside without the key, the following methods are available.
Locking using lock lever
Locking using power door locking switch
In this case, all closed doors and the rear gate are locked at the same time.
Always make sure that all doors and the rear gate are locked before leaving your vehicle.
NOTE
Make sure that you do not leave the key inside the vehicle when locking the doors from the outside without the key.
Note
INSTRUMENTATION/DRIVER INFO > Combination Meter SystemNOTEFor procedure of each component in the combination meter system, refer to the respective section.• Combination meter assembly: Combination Meter">• Speedometer: Speedometer">• Tachometer: Tachometer&quo ...
Preparation tool
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select ...
Electrical specification
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Control Module I/O SignalELECTRICAL SPECIFICATION• Terminal numbers in airbag control module connector are shown in the figure.• The airbag warning light illuminates when the connector is removed from the airbag control module.ItemControl module te ...