Subaru Crosstrek Owners Manual: Locking and unlocking
- Release button
- Mechanical key
While pressing the release button of the access key, take out the mechanical key.
Lock or unlock the driver's door with the mechanical key in the procedure described in "Locking and unlocking from the outside" F2-5.
NOTE
After locking or unlocking, be sure to attach the mechanical key back to the access key.
Access key - if access key does not operate properly
CAUTION
Keep metallic objects, magnetic
sources and signal transmitters
away from the area between the
access key and the push-button
ignition switch. They may interfere
with the communication b ...
Switching power status
1. Apply the parking brake.
2. Shift the select lever into the "P"
position.
3. Depress the brake pedal.
4. Hold the access key with the buttons
facing you, and touch the push-button
ign ...
Other materials:
Dtc p0122 throttle/pedal position sensor/switch "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0122 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving perf ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSTALLATIONCAUTION:• Make sure that the water seal packing on the cover attachment area is securely attached.• Replace the O-rings with new parts, and then apply compressor oil.• Before handling the airbag system compo ...
Dtc u0164 lost communication with hvac control module
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0164 LOST COMMUNICATION WITH HVAC CONTROL MODULEDetected when CAN data is not received from A/C CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
