Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Location

LIGHTING SYSTEM > Relay and Fuse

LOCATION

Main fuse box

Headlight relay (HI)

(A)

Headlight relay (LO)

(B)

Fuse 15 A (daytime running light relay)

(C)

Fuse 30 A (combination light LH/RH)

(D)

Fuse 20 A (spot map light, room light, ignition switch illumination (immobilizer antenna))

(E)

Fuse 15 A (tail and illumination relay, daytime running light relay)

(F)

Daytime running light relay

(G)

Relay & fuse box

Fuse 10 A (stop light and brake switch, brake relay)

(H)

Fuse 10A (inhibitor switch, back-up light switch, auto headlight beam leveler CU)

(I)

Fuse 15A (front fog light relay*2, front fog light relay LH/RH*1)

(J)

Fuse 7.5 A (turn signal & hazard unit)

(K)

Relay holder LH (passenger room)

Tail & illumination relay

(L)

Relay holder RH (passenger room)

Front fog light relay*1

(M)

Relay holder (engine compartment)

Front fog light relay RH*2

(N)

Front fog light relay LH*2

(O)

*1: Model without SRF

*2: Model with SRF

NOTE:

For other related fuses, refer to the wiring diagram. Power Supply Circuit">

Inspection
LIGHTING SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring ...

Room light
...

Other materials:

General precautions when starting/stopping engine
WARNING Never start the engine from outside the vehicle (except when using the remote engine start system). It may result in an accident. Do not leave the engine running in locations with poor ventilation, such as a garage and indoors. The exhaust gas may enter the vehicle or i ...

Read diagnostic trouble code (dtc) Operation
LAN SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «All diagnosis code».NOTE:• For detail ...

Trailer towing tips
CAUTION For models equipped with the BSD (Blind Spot Detection) and RCTA (Rear Cross Traffic Alert) driving support systems, when towing a trailer, press the BSD/ RCTA OFF switch to deactivate the system. The system may not operate properly due to the blocked radar waves. For det ...

© 2016-2024 Copyright www.sucross.com