Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > List of Cancel Code
LIST
Code | Item | Contents of diagnosis |
B2320 | Rear RADAR Low Voltage (less than 9V) | Temporarily stops because the voltage supplied to radar drops below 9 V. Returns to normal when the voltage becomes normal. |
B2321 | Rear RADAR High Voltage (more than 16V) | Temporarily stops because the voltage supplied to radar rises to or above 16 V. Returns to normal when the voltage becomes normal. |
B2328 | Rear RADAR internal failure (RADAR misalignment) | Deviation of the radar axis prevents normal detection. Returns to normal when the radar axis becomes normal. When B2328 is frequently detected, perform “Diagnostic Procedure with Cancel Code”. Diagnostic Procedure with Cancel Code > DTC B2328 REAR RADAR INTERNAL FAILURE (RADAR MISALIGNMENT)"> |
B2340 | RADAR ASSY B&S out of operation temperature range | Temporarily stops because the temperature is outside the operative range (−40°C (−40°F) — 85°C (185°F)). Returns to normal when the ambient temperature falls within the operative range. |
B2341 | Rear RADAR degradation of detecting performance | Temporarily stops because some obstacles blocked radar waves of the back and side radar. Returns to normal when the transmission and reception of radar signals becomes normal. |
Inspection mode Operation
List of diagnostic trouble code (dtc) ListDtc b1827 short in side airbag lh (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1827 SHORT IN SIDE AIRBAG LH (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is shorted to ground.• Side airbag module (LH) is faulty.& ...
43
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code43• The situation that some or all functions for ABS/VDC can not work is detected.During cruise driving or cruise setting, the situation that some or all functions for ABS/VDC can not work is detected. Basic Diagnost ...
Removal
INSTRUMENTATION/DRIVER INFO > Combination MeterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.3. Release the screws, clips and claws, and remove the visor - com ...