INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > User Customizing
LIST
• Combination meter (models with normal meters)
Items to be displayed | Initial setting value | Customize setting | Note |
Air temperature correction | ±0°C | −5°C — +5°C | Temperature compensation can only be performed by 1°C (1°C change = 1.8°F) interval. |
Mean fuel efficiency correction | ±0°% | +10% — −10% | — |
• Combination meter (models with color TFT)
Items to be displayed | Initial setting value | Customize setting | Note |
Air temperature correction | ±0°C | −5°C — +5°C | Temperature compensation can only be performed by 1°C (1°C change = 1.8°F) interval. |
Mean fuel efficiency correction | ±0°% | +10% — −10% | — |
Second level belt warning customize | 2-stage warning implemented | 2-stage warning implemented/2-stage warning not implemented | — |
Demonstration mode permission / fault permission | OFF | OFF/ON | Demonstration mode must not be permitted when used by a customer. |
Basic operation
By operating "
" or "
" of the control
switch, the screens and selection items
can be switched. When the "
/SET"
switch is pulled toward you, the item can
be selected and set.
If there are some useful messages, such
as vehicle information, warning information,
etc., they wi ...
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...