Subaru Crosstrek Owners Manual: Keys and doors
- Keys
- Immobilizer
- Door locks
- Locking and unlocking from the outside
- Locking and unlocking from the inside
- Battery drainage prevention function
- Power door locking switches
- Keyless access with push-button start system (if equipped)
- Access key
- Safety precautions
- Locking and unlocking with "keyless access" entry function
- Selecting audible signal operation
- Warning chimes and warning indicator
- Disabling keyless access function
- Certification for keyless access with push-button start system
- PIN Code Access (models with "keyless access with push-button start system")
- Remote keyless entry system
- Locking the doors
- Unlocking the doors
- Vehicle finder function
- Sounding a panic alarm
- Selecting audible signal operation (models without "keyless access with push-button start system")
- Replacing lost transmitters
- Certification for remote keyless entry system
- Alarm system
- System operation
- Activating and deactivating the alarm system
- If you have accidentally triggered the alarm system
- Arming the system
- Disarming the system
- Valet mode
- Passive arming (models without "keyless access with push-button start system")
- Tripped sensor identification
- Shock sensors (dealer option)
- Child safety locks
- Windows
- Rear gate
- Moonroof (if equipped)
Precautions against vehicle modification
WARNING
To avoid accidental activation of the
system or rendering the system
inoperative, which may result in
serious injury, no modifications
should be made to any components
or wiring of the S ...
Keys
NOTE
For models with "keyless access with
push-button start system", refer to
"Keyless access with push-button start
system" 2-9.
Master key
Submaster key
Sub key
Key number plate
...
Other materials:
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Manual Transmission AssemblyINSTALLATION1. Replace the differential side retainer oil seal. Differential Side Retainer Oil Seal > REPLACEMENT">NOTE:• Be sure to replace the oil seal after removing the front drive shaft.• When a n ...
Inspection
SECURITY AND LOCKS > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection con ...
Dtc b2300 rear radar circuit low
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2300 REAR RADAR CIRCUIT LOWDTC detecting condition:• Short circuit to ground in the harness between radar sensor and outer mirror assembly• Ground short circuit of ...
