Subaru Crosstrek Owners Manual: Keyless buzzer volume setting
1. Perform the preparation steps according to "Preparation for car settings"
2. Operate the "
" or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the
button.
3. Select a volume level by operating the
"
" or "
" switch, and confirm the setting
by pushing the 
button.
4. The system will notify you that the setting is complete.
If the setting is not available, the following notification will be displayed. In this case, perform the setting procedure again.
Preparation for car settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to
show
the selection screen.
3. After the selection screen is displayed,
operate the " " or "
" switch to ...
Hazard warning flasher setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Hazard Warning Flasher" item.Then push the button.
3. The curr ...
Other materials:
Washing the underbody
Chemicals, salts and gravel used for
deicing road surfaces are extremely corrosive,
accelerating the corrosion of underbody
components, such as the exhaust
system, fuel and brake lines, brake
cables, floor pan and fenders, and suspension.
Thoroughly flush the underbody and inside
of the fen ...
Dtc p2196 a/f /o2 sensor signal biased/stuck rich bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2196 A/F /O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...
Dtc u0100 lost communication with ecm/pcm a
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from ECM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...