Preparation for keyless access settings
1. Perform the preparation steps according to "Preparation for car settings"
2. Operate the " " or " " switch to select the "Keyless Access Setting" item.
Then push the button.
Driver's door unlock setting
1. Perform the preparation steps according to "Preparation for keyless access settings"
2. Operate the " " or " " switch to select the "Driver's Door Unlock" item.
Then push the button.
3. The current setting will be displayed.
Push the button to enter the selection mode.
4. Select the preferred setting by operating the " " or " " switch. Then push the button.
5. Select "Set" by operating the " " switch, and confirm the setting by pushing the button.
6. The system will notify you that the setting is complete.
If the setting is not available, the following notification will be displayed. In this case, perform the setting procedure again.
Rear gate unlock setting
1. Perform the preparation steps according to "Preparation for keyless access settings"
2. Operate the " " or " " switch to select the "Rear Gate Unlock" item. Then push the button.
3. The current setting will be displayed.
Push the button to enter the selection mode.
4. Select the preferred setting by operating the " " or " " switch. Then push the button.
5. Select "Set" by operating the " " switch, and confirm the setting by pushing the button.
6. The system will notify you that the setting is complete.
If the setting is not available, the following notification will be displayed. In this case, perform the setting procedure again.
Dtc u0101 lost communication with tcm
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Inspection
EyeSight (DIAGNOSTICS) > General DescriptionINSPECTION1. BATTERYCheck the battery. Battery">2. WINDSHIELD GLASS AND DASHBOARDRemove the windshield glass and dashboard in front of the stereo camera.Standard:There must be no oil film, dirt, scratch or fogging that obstructs the forward vis ...
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the c ...