Subaru Crosstrek Owners Manual: Key reminder chime
The reminder chime sounds when the driver's door is opened and the ignition switch is in the "LOCK" or "ACC" position.
The chime stops under the following conditions.
- when the ignition switch is turned to the "ON" position
- when the key is removed from the ignition switch
- when the driver's door is closed
Lock
The key can only be inserted or removed
in this position. The ignition switch will lock
the steering wheel when you remove the
key.
If turning the key is difficult, turn the
steering wheel slig ...
Ignition switch light (if equipped)
For easy access to the ignition switch in
the dark, the ignition switch light illuminates
when the driver's door is opened or
when the driver's door is unlocked using
the remote keyless entry tran ...
Other materials:
Dtc p0685 ecm/pcm power relay control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0685 ECM/PCM POWER RELAY CONTROL CIRCUIT/OPENDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
Inspection
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSPECTION1. Moving the front tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the hub unit bearing.2. Inspect ...
BSD/RCTA (if equipped)
The BSD/RCTA consists of rear radar with
Blind Spot Detection and Rear Cross
Traffic Alert.
These functions enable the system to
detect objects or vehicles to the rear,
drawing attention to the driver when
changing a lane or when driving in
reverse.
WARNING
The driver is responsible for d ...
