Subaru Crosstrek Service Manual: Intake manifold vacuum Inspection
MECHANICAL(H4DO) > Intake Manifold Vacuum
INSPECTION
1. Turn the ignition switch to OFF.
2. Warm up the engine.
3. Install the vacuum gauge.
(1) Remove the brake booster vacuum hose from the intake manifold.
(2) Connect the vacuum gauge to the intake manifold.
4. Keep the engine at idle speed and read the vacuum gauge indication.
NOTE:
Condition of engine inside can be diagnosed by observing the behavior of the vacuum gauge needle as described in table below.
Intake manifold vacuum (at idling, A/C OFF):
Standard
−60.0 kPa (−450 mmHg, −17.72 inHg) or more
Diagnosis of engine condition by inspection of intake manifold vacuum | |
Vacuum gauge needle behavior | Possible engine condition |
1. Needle is steady but lower than standard value. This tendency becomes more evident as engine temperature rises. | Leakage around intake manifold gasket, disconnection or damage of vacuum hose |
2. Needle intermittently drops to position lower than standard value. | Leakage around cylinder |
3. Needle drops suddenly and intermittently from standard value. | Sticky valve |
4. When engine speed is gradually increased, needle begins to vibrate rapidly at certain speed, and then vibration increases as engine speed increases. | Weak or broken valve springs |
5. Needle vibrates above and below standard value in narrow range. | Defective ignition system |
5. After inspection, install the related parts in the reverse order of removal.
Intake and exhaust valve Specification
MECHANICAL(H4DO) > Intake and Exhaust ValveSPECIFICATIONRefer to “Cylinder Head” for removal and installation procedures of the intake and exhaust valves. Cylinder Head > REMOVAL&qu ...
Piston Specification
MECHANICAL(H4DO) > PistonSPECIFICATIONRefer to “Cylinder Block” for removal and installation procedures of pistons. Cylinder Block > REMOVAL"> Cylinder Block > INSTALLAT ...
Other materials:
Dtc b11f7 side impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F7 SIDE IMPACT DEPLOYMENTDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is displayed when the side airbag module and curtain airbag module are deployed.Once this DTC is displayed, t ...
Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Install each part in the reverse order of removal.2. Install the garnish assembly - fender and the garn ...
Clock/calendar screen setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
"
switch to
select the "Clock" item. Then push the
button.
3. Push the
button once more.
4. Select "Analog Clock", "Digital Clock",
"Calendar" or "Off" by operating t ...
