Subaru Crosstrek Service Manual: Intake manifold

Preparation tool

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18471AA000FUEL PIPE ADAPTERUsed for draining fuel. — SUBARU SELECT ...

Assembly

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldASSEMBLY1. Install the fuel pipe and cap to the intake manifold.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the fuel deliv ...

Other materials:

Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSTALLATIONCAUTION:• Make sure that the water seal packing on the cover attachment area is securely attached.• Replace the O-rings with new parts, and then apply compressor oil.• Before handling the airbag system compo ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldINSTALLATION1. Install the engine wiring harness. Engine Wiring Harness > INSTALLATION">2. Install the intake manifold to the tumble generator valve assembly.NOTE:Use a new gasket.Tightening torque:8.3 N·m (0.8 kgf-m, 6.1 ft- ...

Disassembly
DRIVE SHAFT SYSTEM > Rear AxleDISASSEMBLY1. BUSHING - REAR AXLE HOUSINGDo not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.2. REAR BUSHING1. Remove the rear axle housing. Rear Axle > REMOVAL"&g ...