Subaru Crosstrek Owners Manual: Installation of accessories
Always consult your SUBARU dealer before installing fog lights or any other electrical equipment in your vehicle. Such accessories may cause the electronic system to malfunction if they are incorrectly installed or if they are not suited for the vehicle.
Fuses
CAUTION
Never replace a fuse with one having
a higher rating or with material
other than a fuse because serious
damage or a fire could result.
The fuses are designed to melt during an
overload t ...
Replacing bulbs
WARNING
Bulbs may become very hot while
illuminated. Before replacing bulbs,
turn off the lights and wait until the
bulbs cool down. Otherwise, there is
a risk of sustaining a burn injury.
CAUTI ...
Other materials:
Dtc b1803 short in driver s airbag (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1803 SHORT IN DRIVER’S AIRBAG (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to power supply.• Airbag module harness (driver&r ...
Preparation tool
IMMOBILIZER (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer t ...
Protector tape Installation
EXTERIOR BODY PANELS > Protector TapeINSTALLATIONApply the protector tape by the following steps.1. REAR QUARTER PROTECTOR (MODELS WITHOUT SIDE GARNISH)(1)Apply the protector tape by aligning it to the rounded edge. 1. Clean the area around applying position to remove any foreign objects on bo ...
