Subaru Crosstrek Service Manual: Installation

CAUTION:

Do not reuse the bolt and nut.

Always replace with the specified new bolts and nuts.

1. Before installation, inspect the following items and replace any faulty part with a new part.

• The side airbag sensor, sensor bracket, or connector are damaged.

• Side airbag module has been activated.

• Curtain airbag module has been activated.

Tightening torque:

Side airbag sensor: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

2. Install each part in the reverse order of removal.

NOTE:

Assemble the trim panel - center pillar LWR to the trim panel - center pillar UPR securely.

Tightening torque:

Front seat belt: General Description > COMPONENT">

Side airbag sensor

Removal

Other materials:

Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AWD Warning Light DisplayOPERATIONAWD light illuminates or blinks, when the AWD is in special control condition and AWD has malfunction.• At normal conditionAfter turning the ignition switch to ON, illuminates for 2 seconds then goes off.&b ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the radiator sub fan and fan motor assembly. Radiator Sub Fan and Fan Motor > REMOVAL">3. Lift up the vehicle.4. Remove the under cover. Front Under Cover > ...

Dtc c2422 transmitter 2 battery voltage low
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2422 TRANSMITTER 2 BATTERY VOLTAGE LOWNOTE:Refer to DTC C2424 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2424 TRANSMITTER 4 BATTERY VOLTAGE ...