AIRBAG SYSTEM > Satellite Safing Sensor
INSTALLATION
CAUTION:
• Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.
• When installing the cover - satellite safing, push the cover securely until it contacts the floor panel.
• If the cover - satellite safing is too loose at its mounting portion to remove easily, replace with a new cover - satellite safing.
• After installing the cover - satellite safing, make sure that the sensor harness does not get caught.
1. Before installation, inspect the following items and replace any faulty part with a new one.
• The satellite safing sensor connector is damaged.
• The cover - satellite safing is damaged.
• Side airbag or curtain airbag has been activated.
2. Install the remaining parts in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Note
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemNOTEFor operation procedures of each component of the auto headlight beam leveler system, refer to the respective section.• Auto headlight beam leveler CM: Auto Headlight Beam Leveler Control Module">• Vehicle height sensor: ...
Inspection
GLASS/WINDOWS/MIRRORS > Rear Regulator and Motor AssemblyINSPECTION1. Disconnect the connector of the motor - rear.2. Check the motor operation when battery voltage is applied between terminals of the motor - rear connector.• LH sideTerminal No.Inspection conditionsStandard4 (+) — 1 (&min ...
Replacement
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)REPLACEMENT1. ONLY FOR MODELS WITHOUT EyeSightCAUTION:• Because the pressure sensor built into the H/U is easily damaged by static electricity, start the operation after performing static electrici ...