Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Do not allow harness and connectors to interfere or get tangled up with other parts.

• When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Passenger’s airbag lid (instrument panel surface) is cracked or deformed.

• Airbag module is cracked or deformed.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• Mounting bracket is cracked or deformed.

2. Install the remaining parts in the reverse order of removal.

Tightening torque:

Knee airbag module: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Refer to the installation procedure of the “Instrument Panel Assembly”. Instrument Panel Assembly > INSTALLATION">

Passenger s airbag module

Removal

Other materials:

Dtc p2530 ignition switch run position circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Faulty TCM operationCAUTION:Use the check board when measuring the TCM te ...

Installation
SEATS > Front SeatINSTALLATIONInstall each part in the reverse order of removal.CAUTION:• The front seat mounting bolts differ between the front mounting points and the rear mounting points. When installing the front seat, make sure that you are using correct bolts at correct positions.&bul ...

Dtc b1831 open in curtain airbag rh squib circuit
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1831 OPEN IN CURTAIN AIRBAG RH SQUIB CIRCUITDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) circuit is open.• Curtain airbag module (RH) is faulty.&bul ...