AIRBAG SYSTEM > Front Door Impact Sensor
INSTALLATION
CAUTION:
Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.
1. Before installation, inspect the following items and replace any faulty part with a new part.
• The front door impact sensor or connector is damaged.
• Inner panel area of the panel assembly - front door is deformed.
• Side airbag module has been activated.
Tightening torque:
Front door impact sensor: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
2. Install each part in the reverse order of removal.
Dtc c0021 front right abs sensor circuit open or short
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0021 FRONT RIGHT ABS SENSOR CIRCUIT OPEN OR SHORTNOTE:For the diagnostic procedure, refer to “DTC C0027 REAR LEFT ABS SENSOR CIRCUIT OPEN OR SHORT”. Diagnostic Procedure with Di ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3 ...
Pretensioner connector Procedure
SEAT BELT SYSTEM > Pretensioner ConnectorPROCEDUREFor connectors of seat belt pretensioner, lap seat belt pretensioner and buckle switch RH, refer to “Airbag Connector” of “AIRBAG SYSTEM” section or “OCCUPANT DETECTION SYSTEM” section.• Airbag system: Ai ...