Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Do not allow harness and connectors to interfere or get tangled up with other parts.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Airbag module is cracked or deformed.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• The steering wheel is in the way, making it difficult to install the airbag module.

• The clearance between the driver’s airbag module and steering wheel is not constant.

2. Install the driver’s airbag module.

(1) Connect the airbag connector to the airbag module securely.

CAUTION:

• Be sure to insert the connector in until it is locked.

• Press in the push lock securely. Then pull it gently to make sure that it is locked.

(2) Connect the horn harness.

(3) Press in the locks (three positions) to install the airbag module.

CAUTION:

Make sure that the airbag module locks (three positions) are securely locked.

3. Install each part in the reverse order of removal.

CAUTION:

Make sure that the snap pin is set inside the guide.

Driver s airbag module

Removal

Other materials:

Making a call
There are several methods by which a call can be made, as described below. 1. Press the HOME button on the audio panel. 2. Touch the "PHONE" key. 3. Select the desired key to make a call from the list. Item Function Incoming Calls Display the history of inco ...

Dtc b1822 short in side airbag rh (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1822 SHORT IN SIDE AIRBAG RH (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (RH) circuit is shorted to ground.• Side airbag module (RH) is faulty.& ...

Dtc c0057 vdc interrupted due to egi reason
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0057 VDC INTERRUPTED DUE TO EGI REASONDTC DETECTING CONDITION:Cooperation control prohibition of ECMTROUBLE SYMPTOM:• VDC does not operate.• EyeSight does not operate.NOTE:• ...