Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• When installing the curtain airbag module, install a specified part at specified place.

• Be careful not to damage the curtain airbag module during installation.

• Never open the curtain airbag module before activation. Never reuse the deployed curtain airbag module.

• Make sure that there are no foreign matter on airbag module.

• When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.

• For installation of the stereo camera cover, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION">

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Airbag cover is scratched or torn.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• Mounting bracket and securing clip are cracked or deformed.

2. Install the curtain airbag module.

CAUTION:

• Be sure to insert the connector in until it is locked.

• Press in the push lock securely. Then pull it gently to make sure that it is locked.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

3. Install the remaining parts in the reverse order of removal.

Curtain airbag module

Removal

Other materials:

Dtc c2522 resolver sensor
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2522 RESOLVER SENSORTrouble symptom:• The steering wheel operation feels heavy.• STEERING warning light illuminates.Wiring diagram:Electric power steering system Electri ...

Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...

Registering Bookmarks
You can register the music and artist now being played in Bookmark. 1. Touch the tab. 2. Select the desired key. The following items are appeared on the screen. Item Function Track When selected after the Bookmark key is pressed, the current track is bookmarked. ...