Subaru Crosstrek Service Manual: Installation
AIRBAG SYSTEM > Airbag Control Module
INSTALLATION
CAUTION:
Do not reuse the bolt and nut.
Always use new bolts and nuts for them.
1. Before installation, inspect the following items and replace any faulty part with a new one.
• Control module is deformed.
• Control module connector is damaged.
• Control module mounting bracket is damaged.
2. Install each part in the reverse order of removal.
Tightening torque:
Airbag control module: 25 N·m (2.55 kgf-m, 18.4 ft-lb)
Console box assembly: 6.5 N·m (0.66 kgf-m, 4.8 ft-lb)
Removal
AIRBAG SYSTEM > Airbag Control ModuleREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM ...
Other materials:
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
The starter motor will only operate when
the clutch pedal is depress ...
Removal
EXTERIOR/INTERIOR TRIM > Door TrimREMOVAL1. FRONT DOOR1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - front door.(1) Attach the protective tape (a).(2) Open the cover and remove the screw.(3) Remove the clips, and remove the trim panel - front door from the ...
Removal
SECURITY AND LOCKS > Rear Gate Opener ButtonREMOVALNOTE:• The button - opener rear gate is integrated with the rear lock button. (Model with keyless access with push button start)• Open the panel - rear gate before disconnecting the ground terminal from the battery.1. Disconnect the g ...