Subaru Crosstrek Service Manual: Installation
WIPER AND WASHER SYSTEMS > Washer Tank and Motor
INSTALLATION
1. Install each part in the reverse order of removal.
CAUTION:
• Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).
• Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.
Tightening torque:
6.0 N·m (0.61 kgf-m, 4.4 ft-lb)
2. Add new washer fluid.
3. Adjust the fog light beam. (Model with fog light) Front Fog Light Assembly > ADJUSTMENT">
Removal
WIPER AND WASHER SYSTEMS > Washer Tank and MotorREMOVAL1. WASHER TANK1. Open the hood COMPL - front.2. Disconnect the ground cable from battery. NOTE">3. Remove the bumper face - front. F ...
Other materials:
List
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > System Operation Check ModeLIST• Combination meter (models with normal meters)Check itemItem 1Item 2NoteMeter Needle Movement CheckSpeedometerSpeedometer 0 km/h (MPH) indication — Speedometer 40 km/h (MPH) indication — Speedometer 80 km/h (MPH ...
Basic diagnostic procedure Procedure
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Before performing all diagnostics or cruise control diagnostics, always start the engine and make sure that the initial illumination of the ABS/VDC warning light has been ended. (If you start the diagnostics ...
Inspection
ENTERTAINMENT > Switches and HarnessINSPECTION1. SATELLITE SWITCH ASSEMBLY1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 2VOL (+)VOL (−)SEEK (›)SEEK (‹)LISTRETURNA circuit is all OFF.Approx. 1 ...
