WIPER AND WASHER SYSTEMS > Rear Wiper Arm
INSTALLATION
1. Install in the reverse order of removal.
2. Operate the rear wiper once.
3. Align the blade assembly - rear wiper with the marking on the glass, and then tighten the nut to the specified torque.
Tightening torque:
8 N·m (0.82 kgf-m, 5.9 ft-lb)
4. Operate the wiper to check whether the wiper blade aligns with the point mark. If not, perform installation over again.
Where to place a child restraint system
The following are SUBARU's recommendations
on where to place a child restraint
system in your vehicle.
A: Front passenger's seat
You should not install a child restraint
system (including a booster seat) due to
the hazard to children posed by the
passenger's airbag.
B: Rear seat, window- ...
Adjustment
MECHANICAL(H4DO) > Cam ClearanceADJUSTMENT1. Remove the engine from the vehicle. Engine Assembly > REMOVAL">2. Remove the chain cover. Chain Cover > REMOVAL">3. When adjusting #1 and #3 cylinders(1) Remove the timing chain RH. Timing Chain Assembly > REMOVAL">( ...
Diagnostic procedure for subaru select monitor communication Communication for initializing impossible
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure for Subaru Select Monitor CommunicationCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDIAGNOSIS:Open or short circuit in data link connectorTROUBLE SYMPTOM:Subaru Select Monitor communication failureWIRING DIAGRAM:Engine electrical system Engine Electr ...