WIPER AND WASHER SYSTEMS > Front Wiper Motor and Link
INSTALLATION
CAUTION:
• If the cowl panel assembly cannot be installed properly, do not hit or set it forcibly. The claws of the cowl panel or the windshield glass may be damaged.
• Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.
1. Connect the battery ground terminal. NOTE">
2. To confirm that the motor assembly - windshield wiper is at the auto stop position, connect the harness to the motor and turn the wiper switch to ON/OFF once.
CAUTION:
During motor operation, do not touch the movable part.
3. Disconnect the ground cable from battery again. NOTE">
4. Install the motor assembly - windshield wiper.
(1) Align the link plate position.
CAUTION:
Install the motor assembly - windshield wiper at the position where the rod (B) and link plate (A) are aligned in a straight line.
(2) Install the motor assembly - windshield wiper.
Tightening torque:
5.5 N·m (0.56 kgf-m, 4.1 ft-lb)
5. Install the cowl panel - side and the cowl panel assembly. Cowl Panel > INSTALLATION">
6. Install the arm assembly - windshield wiper. Front Wiper Arm > INSTALLATION">
7. Connect the battery ground terminal. NOTE">
8. Operate the windshield wiper to check that the stop position is aligned with the point mark.
If it is not aligned with the point mark, perform the removal and installation of the windshield wiper over again. Front Wiper Arm > REMOVAL">
9. Make sure that there is a gap of 1 mm (0.04 in) or more between the hose and the cover joint and between the hose and the joint washer hose during windshield wiper operation. (Models with EyeSight)
(A) | Gap between hose and cover joint outer side | (C) | Gap between hose and cover joint inner side | (D) | Gap between hose and cover joint lower side |
(B) | Gap between hose and cover joint upper side |
Defogger setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Defogger" item. Then push the
button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Select ...
Selecting a station from the list (if equipped)
A station list can be displayed.
1. Touch the tab.
2. Touch the tab and the station
list will
appear.
3. Select the desired station.
Update the station list
Touch the "Update Station List" key on the
station list screen and the following screen
will be displayed.
...
Component
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General DescriptionCOMPONENT1. CANISTER, LEAK CHECK VALVE ASSEMBLY AND DRAIN SEPARATORFor structures of the canister, leak check valve assembly and drain separator, refer to “FU (H4DO)”. General Description > COMPONENT" ...