Subaru Crosstrek Service Manual: Installation
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and Hose
INSTALLATION
CAUTION:
Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.
1. Install the nozzle - windshield washer.
(1) Install the nozzle - windshield washer.
(2) Install the hose - windshield washer.
2. Install the cowl panel - side and the cowl panel assembly. Cowl Panel > INSTALLATION">
3. Install the arm assembly - windshield wiper. Front Wiper Arm > INSTALLATION">
4. Install the hose to the joint - washer hose. (Models with EyeSight)
5. Install the cover - joint to the cowl panel assembly. (Models with EyeSight)
6. Adjust the position of the nozzle - windshield washer. Front Washer Nozzle and Hose > ADJUSTMENT">
7. Operate the windshield wiper to check that the stop position is aligned with the point mark.
If it is not aligned with the point mark, perform the removal and installation of the windshield wiper over again. Front Wiper Arm > REMOVAL">
8. Make sure that there is a gap of 1 mm (0.04 in) or more between the hose and the cover joint and between the hose and the joint washer hose during windshield wiper operation. (Models with EyeSight)
(A) | Gap between hose and cover joint outer side | (C) | Gap between hose and cover joint inner side | (D) | Gap between hose and cover joint lower side |
(B) | Gap between hose and cover joint upper side |
Inspection
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseINSPECTION• Make sure the nozzle - windshield washer and the hose - windshield washer are not clogged.• Make sure the hose - winds ...
Front wiper arm
...
Other materials:
Disabling functions
By operating the access key
If you have registered a PIN code for PIN
Code Access, you can disable the keyless
access function by operating the access
key. For details about registering a PIN
code, refer to "Registering a PIN code"
1. Open the driver's door.
2. Rotate the lock lever forwa ...
Dtc u0423 invalid data received from instrument panel cluster control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0423 INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure"&g ...
Electrical specification
SECURITY AND LOCKS > Keyless Entry SystemELECTRICAL SPECIFICATION1. KEYLESS ENTRY CONTROL MODULE• Model without tire pressure monitoring systemTerminal No.ItemMeasuring conditionStandard3 (U-ART com.) — Cannot be measured — 4 (+B) ←> Chassis groundVoltageAlways10 — 14 V7 (GND) ...
