WHEEL AND TIRE SYSTEM > Tire Pressure Monitoring System
INSTALLATION
1. TRANSMITTER (TIRE INFLATION PRESSURE SENSOR)
CAUTION:
Use the new transmitter assembly or replace the new valve and screw, when installing.
1. Replace the valve and screw with a new part when reusing transmitter.
(1) | Screw |
(2) | Transmitter |
(3) | Valve |
Tightening torque:
1.4 N·m (0.14 kgf-m, 1.0 ft-lb)
2. Install the transmitter to the wheel by aligning it with valve hole.
NOTE:
When using the jig that pulls the valve cap by hooking its neck part, use another short-type cap.
3. Install the tires to wheels.
CAUTION:
• Use a tire changer when installing tire to wheel.
• To prevent damaging the transmitter, set the tire changer boom in the position as shown in the figure.
(1) | Transmitter |
(2) | Direction of turn table rotation |
(3) | 135° |
(4) | Tire changer boom |
(5) | 90° |
(6) | Starting point for fitting the bead to the rim |
4. Install the wheels to vehicle. Tire and Wheel > INSTALLATION">
5. Register the transmitter ID to the TPMS & keyless control module. Register Transmitter (ID)">
2. TPMS & KEYLESS CONTROL MODULE
Install each part in the reverse order of removal.
Tightening torque:
13 N·m (1.33 kgf-m, 9.6 ft-lb)
3. TPMS CM
Install each part in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Installation
GLASS/WINDOWS/MIRRORS > Rear Door GlassINSTALLATIONCAUTION:• Check that the running channel - rear door is securely fixed to the panel assembly - rear door and to the sash COMPL - rear partition.• Before installing the glass assembly - rear door, check the lip of the running channel - ...
Before checking or servicing in the engine compartment
WARNING
Always stop the engine and apply
the parking brake firmly to prevent
the vehicle from moving.
Always let the engine cool down.
Engine parts become very hot
when the engine is running and
remain hot for some time after
the engine has stopped.
Do not spill engine oil, engine
coolan ...
Dtc b2810 incompatible with eyesight (combination meter)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2810 INCOMPATIBLE WITH EyeSight (COMBINATION METER)Detected when the combination meter, which is not designed exclusively for EyeSight is installed.DTC DETECTING CONDITION:Incorrect specifications of combination ...