Subaru Crosstrek Service Manual: Installation
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed Sensor
INSTALLATION
CAUTION:
Be careful not to damage the sensor.
1. Install each part in the reverse order of removal.
2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.
NOTE:
Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATION">
Tightening torque:
Rear ABS wheel speed sensor: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
Rear wheel (except for C4 model): 120 N·m (12.2 kgf-m, 88.5 ft-lb)
Rear wheel (C4 model): 100 N·m (10.2 kgf-m, 73.8 ft-lb)
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorREMOVAL1. 5 DOOR MODEL1. Disconnect the ground cable from battery.2. Lift up the vehicle, and then remove the rear wheels.3. Remove the r ...
Other materials:
Dtc u0073 control module communication bus off
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Interior
Passenger compartment area
Lower anchorages for child restraint
system
Seatbelt
Front seat
Rear seat
Buttons for SUBARU STARLINK
NOTE
For U.S.-spec. models with SUBARU
STARLINK: Refer to the Owner's Manual
supplement f o r SUBARU
STARLINK.
Power window switches
Doo ...
Inspection
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLECommunication error with auto headlight beam leveler CMDetecting condition:• Defective harness connector• Power supply circuit malfunction• Defective aut ...
