Subaru Crosstrek Service Manual: Installation
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed Sensor
INSTALLATION
CAUTION:
• Be careful not to damage the sensor.
• Do not apply excessive force to the sensor harness.
Install each part in the reverse order of removal.
NOTE:
• Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATION">
• Check if the harness is not pulled and does not come in contact with the suspension or body while operating the steering.
Tightening torque:
Front ABS wheel speed sensor: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
Front ABS wheel speed sensor bracket: 33 N·m (3.4 kgf-m, 24.3 ft-lb)
Front wheel: Except for C4 model
120 N·m (12.2 kgf-m, 88.5 ft-lb)
Front wheel: C4 model
100 N·m (10.2 kgf-m, 73.8 ft-lb)
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the front wheels.3. Remove th ...
Other materials:
Dtc p219a bank 1 air-fuel ratio imbalance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P219A BANK 1 AIR-FUEL RATIO IMBALANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improper idlingCAUTION:After servicing or ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSTALLATIONCAUTION:If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portio ...
System servicing
WARNING
When discarding a seatbelt retractor
assembly or scrapping
the entire vehicle damaged by a
collision, consult your SUBARU
dealer.
Tampering with or disconnecting
the system's wiring could result
in accidental activation of the
seatbelt pretensioner and/or
SRS airbag or ...
